[Orca-dev] Re: [Orca-users] Tape Throughput

[Blair Zajac]

list2002 at bias.org wrote:
> 
> I'm not sure what you are wanting/expecting from my end.
> 
> It appears you want me to try commenting:
> 
>   // Use the new raw disk code all the time because it has been very
>   // well tested and there are no major bug reports in it.
>   // #define USE_RAWDISK     1
> 
> And then remove all the code I did for tape measuring.  Is this correct?

No.  I'd like to make sure that tape measurements happen regardless of
the USE_RAWDISK setting.  Right now the tape measurement code is in the
#ifdef USE_RAWDISK
#endif

section.  Commenting out USE_RAWDISK is just to make sure that the
tape measurements happen regardless.

> I would have to also alter orcallator.cfg if I did this though?
> 
> It also appears that you have an idea on how to better code the tape
> throughput measurement through separate routine.

Just where to place it, not how the code is coded.

Best,
Blair

-- 
Blair Zajac <blair at orcaware.com>
Web and OS performance plots - http://www.orcaware.com/orca/